|
Sparkley new beads!
Date: 11/23/2003
Views: 2517
|
My studio!
Date: 11/16/2003
Views: 2401
|
The glass rod is heated to a molten state and then wrapped around the mandrel.
Date: 11/16/2003
Views: 2244
|
|
A closer look at my work station.
Date: 11/16/2003
Views: 2214
|
The start of my bead...
Date: 11/16/2003
Views: 2106
|
The tip of the stringer is heated and a dot of glass is added to my bead
Date: 11/16/2003
Views: 1901
|
|
The glass is shaped to an even round in the flame.
Date: 11/16/2003
Views: 1899
|
Fresh beads, straight out of the oven!
Date: 11/23/2003
Views: 1889
|
I put the finished bead into the kiln to begin the annealing porcess
Date: 11/16/2003
Views: 1880
|
|
Applying dots with a white stringer
Date: 11/16/2003
Views: 1879
|
These transparent dots are then melted in.
Date: 11/16/2003
Views: 1877
|
A good side view of more glass being added to the bead.
Date: 11/16/2003
Views: 1874
|
|
The bead is rotated in the cooler part of the flame to finish it off before sending it to the kiln
Date: 11/16/2003
Views: 1855
|
About 10 hours later...the kiln is back to room temperature.
Date: 11/23/2003
Views: 1854
|
The dot is then "spot" heated to soften it.
Date: 11/16/2003
Views: 1840
|
|
A dot of transparent color is added on top of the white dots so it shows up.
Date: 11/16/2003
Views: 1839
|
A closer look at the clear being added to the dots.
Date: 11/16/2003
Views: 1838
|
Close up view of my torch and tools
Date: 11/16/2003
Views: 1834
|
|
A small blob of clear glass is added to the dot and traps a pocket of air, creating a bubble in the center of the dot.
Date: 11/16/2003
Views: 1830
|
The bead is removed from the flame and poked in the center of the dot.
Date: 11/16/2003
Views: 1816
|
This is an AIM84BD kiln with a Fuji digital temperature controller.
Date: 11/16/2003
Views: 1811
|
|
Shaping the glass into a round bead
Date: 11/16/2003
Views: 1810
|
The clear is then melted in flat
Date: 11/16/2003
Views: 1803
|
My kiln is ready to go!
Date: 11/16/2003
Views: 1669
|
